Vinyl Striping

Wet Installation Instructions for Vinyl Striping on Water Resistant Surfaces

To start with, we need to clean the application surface with denatured alcohol, this is the best for removing any oil residue and wax leaving a completely clean surface to apply vinyl to.

WHAT YOU NEED: Paper towels, razor knife to cut and trim, scissors, squeegee (we supply with all orders), denatured alcohol, squirt bottle, detergent soap. And of course vinyl striping supplied by www.vinylstriping.com.

If applying to drywall or similar surfaces apply dry.

install_vinyl_striping1

Step-1 : Saturate surface with a soapy water solution 99.8% water a couple of drops of detergent soap, shake it up. (To add a bit of slipperiness to the water).

install_vinyl_striping2

Step-2 : Pull a foot or two of the vinyl striping away from liner. Apply vinyl gently (get as straight and or as level as you can here).

install_vinyl_striping3

Step-3 : Now saturate the front of the vinyl to help with squeegeeing down onto surface (it will prevent scratching and help with application).

install_vinyl_striping3

Step-4 : Start to squeegee vinyl striping down, the water will squish out and the vinyl will adhere. NOTE: if using vinyl with transfer tape disregard spraying water on top of application tape.

install_vinyl_striping5

Step-5 : At this point work your way down the vehicle a few feet or longer at a time and repeat steps 1 through 4.

Racing Stripes Application Instructions

install-striping1

Step-1 : All surfaces must be clean, Use masking tape to position and create a center hinge. Separate striping from liner as shown.

install-striping2

Step-2 : Use scissors to cut liner and discard.

install-striping3

Step-3 : Gently but firmly use applicator (supplied) to press down striping being careful to apply to much pressure. Use applicator and not your hand to apply striping.

install-striping4

Step-4 : Remove transfer tape at a 180-degree angle onto itself to reduce chance of peeling striping off vehicle. Use razor knife to trim off and slit between door and fenders. And you're done.