Letters Unlimited vinyl lettering
1010 Morse Ave. Unit E
Schaumburg, IL 60193
sales@lettersunlimited.com
vinyl lettering
Custom Vinyl Lettering
800-422-4231

Vinyl Lettering installation instructions

Surface preparation

All surfaces must be considered dirty and must be cleaned prior to the application of markings.

Clean the area where the markings are to be applied with a household cleaner, a non-ammonia base. We recommend an alcohol based cleaner such as denatured alcohol or equivalent. Rinse thoroughly and dry.

When applying vinyl lettering to painted surfaces, paint should be an enamel base paint. We do not recommend or guarantee applications to latex paint.

Temperature requirements

Air and application surface temperatures must be above 40 degrees.

See Alternative instructions for horizontal hinge method.

Step-by-step instructions:

Vinyl Lettering installation instructions: Step 1
1.) Assemble required items. Blue squeegee supplied free with all vinyl letter orders.
Vinyl Lettering installation instructions: Step 2
2.) Clean working area.
Vinyl Lettering installation instructions: Step 3
3.) Measure equal spacing top, bottom, left and right. Measure twice.
Vinyl Lettering installation instructions: Step 4
4.) Fold copy back and apply gentle crease, near center hinge.
Vinyl Lettering installation instructions: Step 5
5.) Remove tack from one end, lay legend over towards center tape hinge.
Vinyl Lettering installation instructions: Step 6
6.) Pull release liner away from application tape and legend until close to hinge.
Vinyl Lettering installation instructions: Step 7
7.) Cut release liner with scissors and discard.
Vinyl Lettering installation instructions: Step 8
8.) Squeegee exposed half of legend, holding the end up and allowing the squeegee to cause contact.
Vinyl Lettering installation instructions: Step 9
9.) Same as Step 8.
Vinyl Lettering installation instructions: Step 10
10.) Remove tape, fold back onto itself and remove release liner.
Vinyl Lettering installation instructions: Step 11
11.) Squeegee exposed half of legend, holding the end up and allowing the squeegee to cause contact.
Vinyl Lettering installation instructions: Step 12
12.) Completely squeegee entire copy with force.
Vinyl Lettering installation instructions: Step 13
13.) Remove application tape by pulling it back onto itself. Be careful not to pull letters up. They may tend to stick to application tape so take your time. Discard tape.
Vinyl Lettering installation instructions: Step 14
14.) Same as step 13.
Vinyl Lettering installation instructions: Step 15
15.) You're done.
 




Letters Unlimited logo   Copyright © 2003-2017 Letters Unlimited, Inc., All Rights Reserved   Mr. Letter Dude